HeyeBeamPowered by Heye Lab
LithoniaEmergency Units

EU2C M6

Contractor Select EU2C dual LED lamp head emergency light - most popular and readily available EU2C configuration.

family: EU Series (Basics) - Contractor Selectvoltage: 120/277Vduration minutes: 90

Cross-References

14 equivalents across 7 brands

Compare top 3 →
  • Sage EmASPpartialSUGGESTED

    Linear LED outdoor egress with emergency lighting, night lighting and Self-test diagnostics with all Battery Backup (BB) models. A dramatic new and compact architectural design, providing powerful emergency and normal lighting for over-door and other exterior locations. The lamp housing and canopy are fabricated from extruded aluminum, in enamel finishes, with rugged sealed diffuser lens and stainless hardware, for wall or ceiling mount. High efficiency LEDs and full 90° cut-off provide uniform emergency and night lighting on the extended egress pathway. All models are outdoor rated, UL wet location, ADA compliant, and exceed requirements of UL Standard 924 and NFPA 101. Designed and manufactured in the USA.

    • category
    • voltage
  • Sure-LitesEBPLEDL Emergency Battery Packsweak

    The Sure-Lites LED Emergency Battery Pack EBPLEDL series allows LED luminaires to be used for emergency lighting when power fails. When a power failure occurs, the EBPELDL switches the luminaire to emergency mode and provides 90 minutes of power for emergency egress lighting. The series are UL924 listed for field retrofit installation and are compatible with Cooper Lighting Solutions LED fixtures. The constant power feature ensures consistent light output for a minimum of 90 minutes.

    • category
    • voltage
    spec →
  • IsoliteE3MINIweak

    The E3MINI Pure Sine Wave Mini Inverter provides a field-selectable 120 or 277 VAC input/output. It is UL 924 and CSA 22.2 approved.

    • category
    • voltage
    spec →
  • Nora LightingNEPK23LEDUNVweak

    Emergency LED driver for use with new or existing LED luminaires. Driver’s circuitry automatically switches the luminaire between emergency and normal power operation during power loss and restoration. Operates at a reduced level for a minimum of 90 minutes to allow safe egress during power outage. Upon restoration to normal AC operation, the emergency driver returns to charging mode. FEATURES Listed for field installation - UL 924 and CSA C2.22 No 141 Controlled power for predictable discharge Includes wall plate with test switch Input Voltage: 120-277VAC Output Voltage: 120VAC (during emergency operation) Output Wattage: 23W Compatible Luminaires: NCSC: 4" & 6" Contractor Series Can-less Downlights NCSD: 6" Contractor Series Disk Lights NCSR: 4" & 6" Contractor Series Retrofits NEFLINTW: 4" & 6" FLIN Can-less Regressed Baffle Downlights NELOSW: 4", 6" & 8" ELO Surface Mounts with Selectable Lumens & CCT NFLAT: 4" & 6" FLAT Can-less Non-Metallic Downlights NFLINA: 4" & 6" FLIN Can-less Adjustable Downlights NFRC: 4" & 6″ Fire Rated Can-less Downlights NJCB-12: 2" & 4" Iolite Can-less Driver Box NLCBC2: 4", 5" & 6" Cobalt Click Retrofits with Selectable CCT NLRS: 6" Sloped Retrofits NLOPAC-R6REGT24TW: 6" Regressed Opal Surface Mount NLOPAC2-R6509T24: 6" Opal 2 Surface Mount NLOS: 4", 6" & 7" SURF Surface Mounts NLTH: 4", 6" & 8" Theia Can-less Downlights NM1-PRDC: 1" M1+ Can-less Downlight NM2: 2" M2 Can-less Downlights NM4: 4" M4 Can-less Downlights NMC: 4" & 6" M-Curve Can-less Adjustable Downlights NMW: 2" & 4" M-Wave Can-less Adjustable Downlights NOXAC-431TW: 4" Onyx Retrofit Reflector with Selectable CCT NOXAC-432TW: 4" Onyx Retrofit Baffle with Selectable CCT NOXAC-4RGTW: 4" Onyx Adjustable Retrofit with Selectable CCT NOXAC-4RWTW: 4" Onyx Round Wall Wash Retrofit with Selectable CCT NOXAC-4SWTW: 4" Onyx Square Wall Wash Retrofit with Selectable CCT NOXAC-5631TW: 5"/6" Onyx Retrofit Reflector with Selectable CCT NOXAC-5632TW: 5"/6" Onyx Retrofit Baffle with S

    • category
    • voltage
    spec →
  • ELCO LightingEE80Lweak

    Mini Emergency Light with two 2W fully adjustable glare-free square shape light heads for emergency light. Injection-molded thermoplastic ABS housing Innovative snap-together design allows for fast and easy installation. 250 lm (total) 3.6V, 1.5Ah battery pack for 90 minutes of emergency operation. LED Driver: 120V/277V AC, dual voltage operation integrated with LED bulb. cUL listed for damp location.

    • category
    • voltage
  • Intelligent Lighting ControlsLLxx-EM UL924 Relay Panelweak

    The LightLEEDer Emergency UL 924 bypass relay control panel will force relay's ON during a normal power outage. This panel has all the same features and functions as a standard LightLEEDer lighting controller, allowing normal control of relays with emergency bypass during a normal power failure event. Relays can be all EM or a combination of normal and EM. Each output has a jumper for selecting Force On, Force Off or No change, this allows for emergency on, load shedding off, or no control selection for each relay. Provided With Phase monitoring module and high voltage dividers. This LightLEEDer Emergency lighting panel is easy to install, no external devices or complicated wiring configurations needed, reducing material and installation costs.

    • category
    • voltage
    spec →
  • TechlightDlgweak

    The DLG Canopy light was designed as a high performance canopy light for parking garages. The removable upper reflector allows for uplight when elimnated. It is segmented to allow the installer to direct the light specifically to the points of egress and away from a driver’s direct line of sight.

    • category
    • voltage
    spec →
  • Sage EmPHOpartialSUGGESTED

    With spacing up to 55 ft in 9 ft ceilings, this recessed down light with a 4" & 6" trim is our most efficient emergency luminaire; very effective in long corridors, it is inconspicuous and will blend with general lighting fixtures without affecting the appearance of ceiling layouts.

    • category
    • environment
    • voltage
  • Sure-LitesINVMweak

    The Sure-Lites INVM Series are a single phase, compact design mini inverter systems that provide 175VA to 1100VA emergency power to LED, fluourescent, incandescent and HID lighting loads. PWM/MOSFET technology provides pure sine wave emergency power (clean power) within 8ms to 24ms of transfer time. Field selectable 120/120 or 277/277VAC input/output allow easier installation. The INVM series are UL 924-listed and provide 90 minutes of emergency power for egress lighting. Small cabinet footprints and multiple mounting means including grid ceiling, recessed wall or standard wall mounted for the 175VA units and floor or wall mounting for the 350VA through 1100VA units allow flexibility for building space limitations.

    • category
    • voltage
    spec →
  • Nora LightingNE806LEDweak

    This low profile fixture offers the lowest profile of all Nora Emergency fixtures. The light sources are held within the body of the fixture, with both beveled side panels constructed of clear polycarbonate. These features make the emergency light small enough for virtually any application, and eliminate the necessity of aiming and locking lamp heads. BODY 11-7/8" Width X 5-1/8" Height X 2-3/4" Depth Injection-molded housing with access for ceiling or wall power supply. FACE Injection molded face with two clear polycarbonate covers on beveled surfaces. MOUNTING Wall or ceiling Mounting hardware included Electrical 120/277V input Automatic solid state switching and charging Automatic reset Battery Replaceable 3.6V, 1000mAh NiCad battery for backup operation during power loss 90 minute emergency operation on fully charged battery Testing High-charge/ready operation indicator light Test button Circuitry Protection Short circuit protection Listings UL 924 NFPA 70 & NFPA 101 Suitable for damp location

    • category
    • voltage
    spec →
  • ELCO LightingEE22Lweak

    Emergency Light with two Adjustable 1.5W LED glare free light heads. 120/277V. Universal mounting plate for fast and easy installation. Sturdy thermoplastic housing. Automatic switching from AC supply to battery power. Long life NiCad battery. cUL Listed for damp location.

    • category
    • voltage
  • Sage EmORIweakSUGGESTED

    A powerful LED fixture designed for very low profile recessed ceiling mount, or optional surface mount, suitable for interior locations, at heights over 40 ft from floor level. Dual function operation in either emergency or optional normal on mode, powered from the Sage central battery at 24VDC.

    • category
  • Nora LightingNE700LEDweak

    Mini profile LED emergency light with remote capability and self diagnostics. Luminaire provides 90 minutas of light from two adjustable heads for illuminating paths of egress upon failure of normal power. FEATURES Plastic enclosure with 5VA flame retardant Snap-together design for easy installation Two fully adjustable glare-free square shape heads Test switch and charge rate indicator Maintenance-free, rechargeable Ni-Cad batteries Extra 3.6V battery for 3W remote capabilities Self-diagnostic and self-testing unit Ceiling or wall mounted Universal 120-277V input CONSTRUCTION Injection-molded thermoplastic ABS housing. Plastic enclosure with 5VA flame retardant. Snap-together design for easy installation. Two fully adjustable glare-free square heads for emergency lighting LABELS AND LISTINGS cULus Listed for Damp locations NFPA

    • category
    • voltage
    spec →
  • ELCO LightingKEM-LDweak

    Single whip for J-Box mounting. 90 minutes of emergency light. 120/277V AC, 60Hz. Bottom lead

    • category
    • voltage

Cross-references are informational starting points — verify with the manufacturer before specifying or purchasing. Spot a bad match? Report it →

Local Reps

Who reps Lithonia

Full directory →

60 rep agencies carry the Acuity Brands line across 51 states. Pick your state.

Line cards are directional — confirm coverage with the agency before routing a spec.